Pilot ZWP10

Remote control ZWP10

Pilot ZWP10Description

The ZWP10 multi-channel remote control enables radio control of FAKRO electrical accessories and of other manufacturers which are compatible with the Z-Wave communication module. The ZWP10 remote control can be used to operate up to 10 devices individually on five channels (two devices per one channel). It also allows the creation of 10 independent groups. Each group can contain several devices operated simultaneously. The controller's memory can contain up to 231 devices. The ZWP10 remote control can serve as the basic controller - PRIMARY and additional controller - SECONDARY. The PRIMARY controller allows to integrate numerous devices into one radio network, while the SECONDARY controller acts as additional controller in already existing network. In addition to Basic control mode, i.e.: OPEN, STOP, CLOSE, the ZWP10 remote control also features Multilevel mode which allows e.g. for smooth dimming of light and for convenience can also be magnetically wall mounted.


Technical specification: ZWP10
power supply: 3VDC, batteries 2xAAA, 1,5[V]
operating range in open area: up to 40[m]
radio protocol: Z-Wave
working frequency: 868,42 [Hz] (EU)
dimensions (length/width/height): 157/38/19


Programming the Controller

If the device has not been purchased with the controller in a set, it should be programmed. If the network is configured again, it is necessary to reset the controller to factory settings (DEFAULT function) by following the steps below:


szybki start

  1. Choose one of five channels on which the device is to be assigned by pressing SELECT button.
  2. Press IN/EX button on the back of the controller. If LED’s 1 and 4 light up, then press one of movement buttons of a given group until LED’s change for 1,2,3.
  3. Within 10 seconds press P button on the device until the network status LED is off (see device programming manual).
  4. LED’s 2, 3 & 4 will light up to show that the controller is formatting correctly.
  5. If LED’s 1, 2 & 3 light up then the procedure has failed and the process should be performed again from point 2.
  6. Now wait 10 seconds, after which the controller is ready to operate.

 szybki start





The ZWP10 remote control enables radio control of FAKRO accessories and of other manufacturers which are compatible with the Z-Wave communication system. The ZWP10 remote control is equipped with a two-way Z-Wave communication radio module which exploits radio wave frequency 868,42 MHz EU (frequency depending on the country for which the product is intended).

The ZWP10 remote control enables operation of the following FAKRO accessories:

  • ZWS12, ZWS230 actuator
  • ARZ Z-Wave external roller shutter
  • AMZ Z-Wave awning blind
  • VMZ Z-Wave vertical awning blind
  • VMB Z-Wave vertical markizoleta
  • ARF Z-Wave blackout blind, ARP Z-Wave roller blind
  • AJP Z-Wave Venetian blind
  • FTP-V Z-Wave, FTU-V Z-Wave window
  • DEC Z-Wave, DEF Z-Wave flat roof window


    Instructions Film installation instructions

User manuals:                

Instructions Catalogues and Brochures